was kind enough to let us pick out a little somethin’ for a DIY project! Naturally we were drawn to SF local- Yellow Owl Workshop’s stamp-carving kit, though it was a tough call since they offer a ton of great DIY kits. We decided we wanted to do a bandana using a neon color palette, our most recent obsession. Follow the instructions below to create your own stamped bandana. In addition we will offer up $40 gift cards to UncommonGoods to TWO lucky winners. Find contest guidelines below!
Happy crafting!
created this genius Carve-A-Stamp Kit that contains everything you need to master the art of stamp carving.
The kit comes equipped with: • 2 rubber blocks mounted on wood for carving • 1 brilliant red ink pad • 1 pencil • 1 wood carving knife with five tips & a tip remover • 1 template featuring different designs • 1 piece of tracing vellum • 1 muslin bag
What you will need in addition for this project: • 1 yard of muslin • washable/ fabric friendly neon ink pads • scissors • neon thread (optional) • a sewing machine (optional) • one extra block of rubber (optional)
*All of these items can be found at Michaels, or the craft store of your choice. STEP ONE:
Carving the dot pattern stamp-
We used the semi circle tip in order to cut out our dots for our reversed dot stamp. First use your pencil to draw scattered dots. Then push the semi-circle into the rubber, rotate 360 degrees, and pop the rubber out. Repeat until your pattern is complete.
STEP TWO:
Carving the star pattern stamps-
Draw the star onto the rubber with your pencil. Then use the flat knife to trace the outline of your star. After, use that same tool to remove ¼ inch of the entire surrounding area. In order to achieve only the outline of the star, you will then use the wide “V” carving tool to remove the rubber from the inside of the star.
*note: If you wish to create another star stamp, repeat the steps listed above with your extra rubber pad.
STEP THREE:
Cutting out your bandana- Cut a 23 inch square out of your muslin. This allows for a ½ seam allowance on each side. Using your neon thread, iron, pin, & sew the edges in.
*note: if you would not like to sew the edges, cut out a 22 inch square & leave it raw!
STEP FOUR:
Stamping your bandana- Using the dot stamp you have created, line up the block along the edge and make a border all the way around. Then fill the center with your star stamps as seen above.
STEP FIVE:
Protect your fabric- Wait until the ink has dried (a few hours). Place a piece of muslin over your pattern and iron each side without water/steam. Allow for a week or so before washing, then hand wash or machine wash alone for first rinse.
STEP SIX:
Strut around in your new bandana.
We made two bandanas, one for our pen pal, and another tiny one for Imogen because we couldn’t resist, duh.
Jump the gun and make one for mom for Mothers day! Get your own kit here! Or check out more great mom day ideas here.
CONTEST GUIDELINES:
Enter to win a $40 gift card to UncommonGoods to snag your own stamp carving kit and then some!
All you gotta do is like UncommonGoods on facebook & comment on this post! Don’t have a facebook? Join their newsletter instead!
Our winner's will be announced Friday the 21st!
